POWERTRONIC INTELLIGENT PTi I

Product family features
  • Energy Efficiency Index EEI: A2
  • Supply voltage: 220…240 V
  • Line frequency: 50…60 Hz
  • RI suppression: to EN 55015/CISPR 15
  • Safety: to EN 61347-2-12
  • Line harmonics according to EN 61000-3-2
  • Immunity according to EN 61547
Product family benefits
  • Extended terminal section enables mains looping
  • Screw-down cable clamps for reliable strain relief
  • Long reliable life at maximum permitted temperatures
  • Automatic safety shutdown of lamps in the event of a defect or at end of life (EoL)

Products

Sort by:
Product
Height
Length
Nominal voltage
Lamp wattage
Ignition voltage
Data sheet
PTi 35/220…240 I
32.0 mm 171.0 mm 220…240 V 39 W 4.5 kVp
PTi 70/220…240 I
32.0 mm 171.0 mm 220…240 V 73 W 4.5 kVp
PTi 150/220…240 I
33.0 mm 212.0 mm 220…240 V 147 W 4.5 kVp

Information about Family

POWERTRONIC INTELLIGENT PTi I is an electronic control gear (ECG) for use with high intensity discharge lamps, that has an energy efficiency index (EEI) of A2. It is supplied with screw-down cable clamps for reliable strain relief, and you may find it particularly good for use in shoplighting, health and fitness spaces (in dry, corrosion-protected areas) and for effect and accent lighting. It has an extended terminal section that enables mains looping, and a long lifespan at maximum permitted temperatures. POWERTRONIC INTELLIGENT PTi I gives you reliable service and provides automatic lamp shutdown in the event of a defect or end of life.
Areas of application
  • Shop lighting
  • Health and fitness areas (in luminaires with protection class IP66 or higher)
  • Effect and accent lighting

Safety advice
Ballast losses and lamp heat radiation can lead to heat accumulation in a completely closed case. Therefore it is necessary to ensure that the temperature at the measuring point t of the ECG does not exceed the maximum value.
Attention!
For safety reasons disconnect the device before replacing the lamp!

Ecodesign regulation information:
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.

Downloads